PDA

View Full Version : Valet Mode


Trever1T
October 18th, 2009, 09:32 AM
In the speedo tab of HPT I lowered all speed limiters to 45mph.

Speedo--->Speed limiter

I also set Rev limit off to 3000rpm on at 2999 rpm.

Engine--->fuel controll--->fuel cutoff--->cutoff rpm vs. gear normal.

I took it for a drive and it works great. Try going into boost and it shuts down, take it over 45 and it gently cuts off. Dropped the truck at the painters and now I can be assured nobody will be taking joy rides ;)

RrCoX22
October 18th, 2009, 08:43 PM
you are superman... very nicely done :thumbsup:

was reading this think what the hell are you doing??? :banghead: a temporarily low jack would work too. but would need constant attention. you have knowingly guaranteed satisfaction

Trever1T
October 19th, 2009, 06:22 AM
I drove it to the paint shop like that, wanted to make sure it was drivable on surface streets under normal conditions. Trying to abuse it or go above 45mph just cut fuel/spark. I don't think the business would purposely hotrod around but you know, the temptation is just too much for some people :P